![]() Create a primary partition: Use n, then p.Enter the fdisk utility for the appropriate device ('sda').Typically, your USB storage would be identified as sda: We will assume this is the case in further documentation. NOTE: you can find your devices in many other ways: try for instance lsblk Figure out first which drive is your USB. ![]() The second will be used for data of your choice. As mentioned, the system partition is going to be used mainly for preserving the life of your SD card. For this scenario, we will setup two: one for system, one for data. Now is the time to tweak the mentioned memory setting to 16 MB (via raspi-config) ![]() Login remotely using your credentials of a SUDO user.Note that using a USB hub might bring some issues, it is a good idea to plugin this USB stick directly into RasPi (after all it boots a system).If it contains data however, make sure it is backed up: we will wipe it Plugin a USB stick with big enough storage for your purpose (note you need to extract 4GB for the system, as described below). ![]() If you are going to continue headless, you can change the amount of graphics memory to something like 16 megabytes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |